On the first visit we measure the movement and mark where it sits, and the quote follows in writing. That first visit also tells you whether this is a maintenance job or one that needs a structural engineer's report.
What do we record on the first visit?
We sketch the floor plan or the relevant elevations and mark every finding in its exact spot. That sketch is the map we come back to if the movement changes.
Then we run a manometer level across points in the structure to get relative floor elevations, and we write down the benchmark we compared against. Without a named benchmark, a floor reading can't be checked later.
We also record crack widths and locations, plus moisture readings where they're relevant. A crack width today only means something next to a width taken later at the same spot.
When you are ready, deck patio and porch structural design is the place to start. Searching for a structural engineer in Walnut Creek? See our home page.
Is it the soil moving or the house?
Local soils formed in loamy residuum weathered from sandstone and shale, and that ground does the moving under area foundations. Around 16.1 inches of precipitation falls over a year here, concentrated in the rainy season. The ground gets its heaviest wetting in January (about 3.2 inches) and is dry by July. A crack measured in winter and again in late summer shows whether the movement follows that cycle or keeps going in one direction.
Your floor plan matters too. An Eichler in Rancho San Miguel, for example, is post-and-beam with wood siding on a slab foundation, so we check the individual home's framing and foundation before anyone plans alterations.

When can the work wait?
Often it can. If the movement is in a single room and crack widths haven't changed between readings, we'll tell you to watch it instead of repairing it. We note that on the sketch so you have a baseline for the next check.
If the readings show the tilt running through several rooms, or the cracks keep opening, waiting only lets the repair grow. We'll say which case you're in and why.
When does a repair need an engineer and a permit?
Anything that goes beyond maintenance usually needs an engineer's written report. Separately, permit applications received in Walnut Creek from January 1, 2026 onward have to meet the 2025 California Building Code and 2025 California Residential Code, so the repair design is drawn to those.
Retaining walls are the one to watch on sloped lots. A wall that supports a surcharge, such as sloping ground or a parking area, triggers both a building permit and a site development permit. If your movement is tied to a wall like that, we'll flag it at the first visit so it doesn't surprise you later.
What does it cost, and what happens when you call?
If the question is your roof framing rather than the floor, a structural roof inspection runs $175 to $725. A bigger house, an addition, or more measuring points means more time on site, and the price climbs with it. The written quote states the final price, and you'll have it in hand before any work begins.
On the call, describe the symptoms and roughly when the house went up. We'll ask where the symptoms show up, then schedule the visit. Repair decisions wait until after we've measured.
What Goes Into the Work
Spelled out, these are part of it:
- For a design project, assess site conditions and structural loads before sizing beams, columns, walls, or foundations.
- Prepare structural drawings and calculations, then observe construction as needed to check the work against the approved plans.
Typical Walnut Creek Pricing
Most jobs land inside these ranges, and yours gets its own written price once we've seen it.
$425–$1,100
$350–$900
$300–$1,200
Also Available
Questions Welcome
Calling is the simplest way to start, you'll get an honest answer.
Updated October 2026
